Water-based PE breathable film ink

N13 Water-based series—Gravure water-based PE breathable film ink (for diapers)

N13 water-based gravure ink for PE diapers is developed by the company itself, safe and environmentally friendly, suitable for gravure rotary printing. This product is mainly suitable for PE breathable film (for diapers).

1. Product features:

High color density, low viscosity

Good printability and fast drying speed

Strong adhesion, excellent weather resistance, water resistance and abrasion resistance

Water or ethanol is used as the diluent, the printed product has no peculiar smell, and the residual VOCs has passed the FDA inspection

2. Applicable substrate:

PE breathable film (for diapers)

Note: Please pass the full test before use.

3. Technical indicators:

Network cable: 65~70 line

Dot depth: 30~35μ

Dot angle: 45~60 degrees

4. Instructions for use:

Thinner: pure water or ethanol (the configuration of the thinner depends on the printing equipment and climatic conditions, please pass a sufficient test before using) Printing viscosity: Zahn 3# cup (25℃) 10~14 seconds, printing The time can be adjusted according to the printing speed.

Five, matters needing attention:

● Fully stir before use, so that the ink has good fluidity.

● The ink system of our company is unique and cannot be mixed with other types of ink to avoid incompatibility resulting in scrap.

● Drying conditions: The temperature of the hot air at the outlet of the oven should be maintained during printing: about 55°C (the air inlet of the fan should be large so that the moisture can be quickly removed).

● The water-based ink is insoluble in water after drying and forming a film, so you must pay attention to the printing process and the end of printing:

● Hot air direction: The hot air of the oven can not be blown onto the printing plate to avoid the ink drying and blocking the plate from being unable to print normally;

● Prevent plate blocking: The plate roller must be kept rotating in the ink tank when replacing the substrate or temporarily stopping the machine. If the machine is down due to a mechanical failure, the plate roller should be cleaned immediately with water or ethanol to prevent the ink from drying out and blocking the plate.

● Plate roller cleaning: After printing, the plate roller must be cleaned immediately with water, alcohol or detergent liquid or a special plate washing liquid prepared by our company (note that the washing liquid cannot be poured into the ink tank if the plate is washed with detergent liquid) For normal use next time.

● Recycling of residual ink: After printing, put the remaining ink in a clean plastic bucket. The mouth of the bucket must be sealed, and it must be filtered when it is reused.

The above data is only obtained by our company. Depending on the materials used and processing conditions, the results will not be the same, please confirm before using.

6. Storage and packaging:

Storage: As for the sealed storage in a ventilated and cool place, fire and sun protection, avoid rain and pollution, the shelf life is one year.

Packing: plastic drum, 18KG/drum, 20KG/drum, 25KG/drum, 50KG/drum

Warning to users: The information in this article is based on the company's internal production and experimental results. Users should conduct sufficient tests before use to ensure that the product meets their own use requirements and master the correct use of the product. Due to the unforeseen and inability to control the user's product use conditions, the information in this article is for users' reference only. It is not the basis for the quality of the work, and it does not bear joint and several liability for the results of the use of the product.